Right Rear Seat-back Lock Control Cable Replacement

NOTE:
  • Take care not to tear the seams or damage the seat covers.
  • Put on gloves to protect your hands.

1.Remove the armrest.

2.Release the bottom hook, unzip the seat-back cover, then fold back the cover.

3.Release the hook strips from the edge of the armrest back cover.

4.Remove the armrest back cover.

5.Release the hook strips at the armrest portions from the back of the seat-back.

6.Pull up the bottom of the seat-back pad (A) half-way apart from the seat-back frame (B).

 

7.Disconnect the seat-back lock control cable (A) from the inner recline adjuster (B) and the outer recline adjuster (C). Release the clamps (D), then remove the cable.

 

8.Install the cable in the reverse order a removal, and note these items:

  • After reconnecting the cable, adjust its tension with its adjusting nuts (D).
  • Replace any clamps you removed with new ones.
  • To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hooks.