Wiper/Washer Switch Test/Replacement

1.Remove the driver's dashboard lower cover.

2.Remove the steering column covers.

3.Disconnect the 14P connector (A) from the wiper/washer switch (B).

LHD type and KE model: 

RHD type: 

4.Remove the two screws, then pull out the wiper/washer switch.

5.Inspect the connector terminals to be sure they are all making good contact.

  • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
  • If the terminals look OK, check for continuity between the terminals in each switch position according to the tables. If the continuity is not as specified, replace the switch.


Rear Window: