Rear Door Glass and Regulator Replacement

NOTE: Put on gloves to protect your hands.

1.Remove these items:


2.Carefully move the glass (A) until you can see the bolts, then remove them. Remove the glass from the regulator (B), and carefully lower the glass. Take care not to drop the glass inside the door.

 

3.Pull the glass run channel (A) away as needed. Pull back the door quarter glass seal (B), then remove the screw (C). Remove the bolts (D, E) securing the center channel (F), then remove the collar (G).

 

4.Pull the upper portion of the center channel (A) forward to remove it from the door quarter glass seal (B), and pull up the center channel. Take care not to scratch the door.

 

5.Remove the door quarter glass (A) and seal (B) as an assembly from the door.

 

6.Release the glass (A) from the center channel (B), and carefully remove the glass out though the window slot. Take care not to drop the glass inside the door.

 

7.Disconnect and detach the connector (A) from the door.

 

8.Remove the bolts (B), and loosen the bolts (C), then remove the regulator (D) through the hole in the door.

9.Grease all the sliding surfaces of the regulator (A) where shown.

 

10.Install the glass and regulator in the reverse order of removal, and note these items: