Rear Driveshaft InstallationNOTE: Before starting installation, make sure the wating surfaces of the joint and the spline section are free from dirt or dust.
|1.||Install the outboard joint (A) into the rear hub (B).|
NOTE: Be careful not to damage the ABS wheel sensor (C).
|2.||Install the rear driveshafts into the rear differential assembly.|
|3.||Apply a small amount of engine oil to the seating surface of the new spindle nut (A).|
|4.||Install a new spindle nut, then torque the nut. After tightening, use a drift to stake the spindle nut shoulder against the driveshaft (B).|
|5.||Clean the mating surfaces of the brake disc and the wheel, then install the rear wheel and torque the wheel nuts.|