DTC Troubleshooting: P0108 (3-2)

DTC P0108 (3-2):  MAP Sensor Circuit High Voltage

1.Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on, then let it idle with no load.

2.Check the MAP with the scan tool.

Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the  MAP sensor and at the  ECM/ PCM.n


3.Turn the ignition switch OFF.

4.Disconnect the MAP sensor 3P connector.

5.Connect MAP sensor 3P connector terminals No. 2 and No. 3 with a jumper wire.

 


6.Turn the ignition switch ON (II).

7.Check the MAP with the scan tool.

Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?


YES - Go to 8.


NO - Replace the  MAP sensor.n


8.Remove the jumper wire.

9.Measure voltage between MAP sensor 3P connector terminals No. 1 and No. 3.

 

Is there about 5 V?


YES - Go to 10.


NO - Repair open in the wire between the  ECM/ PCM (A11) and the  MAP sensor.n


10.Turn the ignition switch OFF.

11.Connect ECM/PCM connector terminals A11 and A19 with a jumper wire.

 

12.Turn the ignition switch ON (II).

13.Check the MAP with the scan tool.

Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?


YES - Substitute a known-good ECM/PCM and recheck. If the symptom/indication goes away, replace the original  ECM/ PCM.n


NO - Repair open in the wire between the  ECM/ PCM (A19) and the  MAP sensor.n