A/T End Cover Removal

Exploded View -4WD


Exploded View -2WD


Special Tools Required
Mainshaft holder set (  07PAB-0010000)

NOTE: Refer to the Exploded View as needed during the following procedure.

1.Remove the ATF cooler lines.

2.Remove the A/T clutch pressure control solenoid valve A, then remove the ATF pipe, ATF joint pipes, and gasket.

3.Remove the A/T clutch pressure control solenoid valves B and C, then remove the ATF joint pipes and gasket.

4.Remove the transmission range switch cover.

5.Remove the transmission range switch harness clamps from the clamp brackets, then remove the transmission range switch.

6.Remove the end cover.

7.Slip the special tool onto the mainshaft.


8.Engage the park pawl with the park gear.

9.Cut the lock tab (A) of the each shaft locknut (B) using a chisel (C). Then remove the locknuts and conical spring washers from each shaft.

  • Countershaft and secondary shaft locknuts have left-hand threads.
  • Keep all of the chiseled particles out of the transmission.
  • Clean the old mainshaft and countershaft locknuts; they are used to install the press fit idler gear on the mainshaft, and park gear on the countershaft.


10.Remove the special tool from the mainshaft.

11.Set a tow-jaw (or three-jaw) puller (A) on the countershaft (B) with putting a collar (C) between the puller and countershaft, then remove the park gear (D).


12.Install 6 x 1.0 mm bolts (A) on the mainshaft idler gear (B). Set a puller (C) on the mainshaft (D) with putting a collar (E) between the puller and mainshaft, then remove the mainshaft idler gear.


13.Remove the park pawl, park pawl spring, park pawl shaft, and stop shaft.

14.Remove the park lever from the control shaft.