A/T Housing Bearing Removal
Special Tools Required
Snap ring pliers ( 07LGC-0010100)
Handle driver ( 07749-0010000)
Driver attachment, 42 x 47 mm ( 07746-0010300)
1. | Remove the idler gear shaft when removing the mainshaft bearing and idler gear shaft bearing. NOTE: If you are only removing the countershaft bearing, idler gear shaft removal is not needed. |
2. | To remove the mainshaft bearing (A) and countershaft bearing (B) from the transmission housing, expand each snap ring with the snap ring pliers, then push the bearing out. NOTE: Do not remove the snap ring unless it's necessary to clean the grooves in the housing.
|
3. | Expand the snap ring of the idler gear shaft bearing with the snap ring pliers, then push the bearing out.
|