Secondary Shaft Ball Bearing, Idler Gear Removal and Installation

Special Tools Required
Driver attachment, 42 mm I.D. (  07QAD-P0A0100)
 



NOTE: The illustration shows the K20A4 and K20A5 engine models; the K24A1 engine model is similar.

Removal


1.Place a shaft protector (A) on the secondary shaft (B), and set the puller (C) to the idler gear (D), then remove the idler gear and ball bearing (E).

 

Installation


1.Install the idler gear (A) on the secondary shaft (B), and install the ball bearing (C) over the idler gear with the special tool and a press.