A/T Selector Hub and 4th Gear Collar Removal

Special Tools Required
Bearing separator (  07KAF-PS30200)

K20A4 and K20A5 Engine Models

  • Some reverse selector hubs and 4th gear collars are not press-fitted, and can be removed without using the special tool and a puller.
  • Place a shaft protector between the countershaft and a puller to prevent damaging the countershaft.

1.Remove the reverse selector hub (A) and 4th gear (B) with the special tool, a two-jaw (or three-jaw) puller (C), and a shaft protector (D).


2.Install the special tool with inserting it to the opening between 31 x 50 x 18.5 mm collar (A) and 4th gear collar (B). Set the puller (C) to the special tool, then remove the 4th gear collar.