Transfer Assembly Disassembly

Exploded View

 

Special Tools Required
Companion flange holder (  07PAB-0020000)
 



NOTE: Refer to the Exploded View as needed during the following procedure.

1.Remove the transfer holder (A) from the transfer housing (B).

 

2.Cut the lock tab on the locknut using a chisel.

 

3.Secure the transfer housing (A) in a bench vise (B) with soft jaws. To prevent damage to the transfer housing, always use soft jaws or equivalent materials between the transfer housing and the vise.

 

4.Install the special tool on the companion flange, then loosen the locknut.

5.Remove the special tool.

6.Remove the locknut (A), conical spring washer (B), back-up ring (C), O-ring (D), and companion flange (E) from the transfer driven gear (F).

 

7.Remove the transfer driven gear (A) from the transfer housing (B), then remove the transfer spacer (C) from the transfer driven gear.

 

8.Remove the oil seal (A) and tapered roller bearing (B) from the transfer housing (C).