Transfer Driven Gear Bearing Removal/Installation

Special Tools Required
Driver 40 mm I.D. (  07746-0030100)
 

Driver attachment, 35 mm I.D. (  07746-0030400)
 


1.Remove the tapered roller bearing (A) from the transfer driven gear (B) with a bearing separator (C) and a press. Place a shaft protector (D) between the transfer driven gear and a press to prevent damaging the transfer driven gear.

 

2.Install the 35 mm thrust shim (A) on the transfer driven gear (B).

3.Install the tapered roller bearing (C) on the transfer driven gear with the special tools and a press.