DTC Troubleshooting: P0745 (76-1)
|DTC P0745:||Problem in Hydraulic Control System of A/T Clutch Pressure Control Solenoid Valve A Circuit|
NOTE: Record all freeze data before you troubleshoot.
|1.||Check the fuel and emissions system problem or A/T system problem is indicated by the DTC.|
Is there any of the DTC?
YES - Perform the troubleshooting flowchart for the indicated code(s). Turn the ignition switch OFF, and go to 4 after troubleshooting.
NO - Go to 2.
|2.||Turn the ignition switch OFF.|
|3.||Replace the A/T clutch pressure control solenoid valve A.|
|4.||Reset the PCM memory by removing the No. 6 ECU fuse (15A) in the under-hood fuse/relay box for more than 10 seconds.|
|5.||Start the engine, and shift to  position. Start the vehicle off in  position, drive at 19 mph (30 km/h) for 10 seconds, shift into  position, drive at 19 mph (30 km/h) for 10 seconds, then decelerate to a stop.|
|6.||Repeat step 5 to test-drive the vehicle.|
|7.||Recheck for DTC P0745.|
Is DTC P0745 indicated?
YES - Replace the transmission assembly.n
NO - The problem has been corrected.n