DTC Troubleshooting: P0775 (77-1)
DTC P0775: | Problem in Hydraulic Control System of A/T Clutch Pressure Control Solenoid Valve B Circuit |
NOTE: Record all freeze data before you troubleshoot.
1. | Check the fuel and emissions system problem or A/T system problem is indicated by the DTC.
Is there any of the DTC?
YES - Perform the troubleshooting flowchart for the indicated code(s). Turn the ignition switch OFF, and go to 4 after troubleshooting.
NO - Go to 2.
|
2. | Turn the ignition switch OFF.
|
4. | Reset the PCM memory by removing the No. 6 ECU (15 A) fuse in the under-hood fuse/relay box for more than 10 seconds.
|
5. | Start the engine, and shift to [2] position. Test-drive the vehicle in [2] position at 25 mph (40 km/h) for 10 seconds, shift into [D] position with over-drive OFF mode in 3rd gear, drive at 25 mph (40 km/h) for 10 seconds, then decelerate to a stop. Do not stop the engine. Start off in [1] position, and drive at 19 mph (30 km/h) for 10 seconds.
|
6. | Repeat step 5 to test-drive the vehicle.
|
7. | Recheck for DTC P0775.
Is DTC P0775 indicated?
YES - Replace the transmission assembly.n
NO - The problem has been corrected.n |