IMRC Valve Replacement

1.Remove the intake manifold.

2.Disconnect the vacuum hose (A).


3.Remove the bolts (B).

4.Remove the IMRC actuator assembly (C).

  • When installing the IMRC actuator, make sure the bearing (E) is firmly secure into place if necessary.
  • Do not the IMRC assembly interfere with the intake manifold (F).
  • When installing the IMRC actuator, replace the new O-rings (D).

5.Install the IMRC actuator assembly (A), then check the hole (B) appears.


6.Turn the IMRC actuator assembly (A), and set the bolt holes.

NOTE: When turning the IMRC actuator assembly, make sure the stopper (B) and groove (C) are fit.