Side Impact Sensor Replacement

Removal


NOTE:

1.Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.

2.Remove the seat assembly.

3.Remove the rear side trim panel.

4.Disconnect the floor wire harness 2P connector from the side impact sensor.

5.Remove the Torx bolt (A) using a Torx T30 bit, then remove the side impact sensor (B).

 

Installation


NOTE:

1.Install the new side impact sensor with a new Torx bolt (A) then connect the floor wire harness 2P connector (1) to the side impact sensor (B).

 

2.Reconnect the negative battery cable.

3.After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.