ABS Modulator-Control Unit Removal and Installation

NOTE:

Removal


1.Turn the ignition switch.

2.Disconnect the negative cable from the battery.

3.Pull up the lock (A) of the ABS control unit 47P connector (B), then disconnect the connector.

 

4.Disconnect the six brake lines.

5.Remove the ABS modulator-control unit (C)/bracket (D) from the body.

6.Remove the two 6 mm shoulder bolts and the 6 mm bolt from the bracket, then remove the ABS modulator-control unit from the bracket.

Installation


1.Install the ABS modulator-control unit to the bracket, then tighten the two 6 mm shoulder bolts and the 6 mm bolt.

2.Install the ABS modulator-control unit/bracket to the body.

3.Align the connecting surface of the ABS control unit 47P connector.

4.Push in the lock of the ABS control unit 47P connector, then connect the connector.

5.Connect the six brake lines.

6.Bleed the brake system, starting with the front wheels.

7.Start the engine, and check that the ABS indicator and brake system indicator go off.

8.Test-drive the vehicle, and check that the ABS indicator and brake system indicator do not come on.