ABS Modulator-Control Unit Removal and InstallationNOTE:
- Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
- Be careful not to damage or deform the brake lines during removal and installation.
- To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
|1.||Turn the ignition switch.|
|2.||Disconnect the negative cable from the battery.|
|3.||Pull up the lock (A) of the ABS control unit 47P connector (B), then disconnect the connector.|
|4.||Disconnect the six brake lines.|
|5.||Remove the ABS modulator-control unit (C)/bracket (D) from the body.|
|6.||Remove the two 6 mm shoulder bolts and the 6 mm bolt from the bracket, then remove the ABS modulator-control unit from the bracket.|
|1.||Install the ABS modulator-control unit to the bracket, then tighten the two 6 mm shoulder bolts and the 6 mm bolt.|
|2.||Install the ABS modulator-control unit/bracket to the body.|
|3.||Align the connecting surface of the ABS control unit 47P connector.|
|4.||Push in the lock of the ABS control unit 47P connector, then connect the connector.|
|5.||Connect the six brake lines.|
|6.||Bleed the brake system, starting with the front wheels.|
|7.||Start the engine, and check that the ABS indicator and brake system indicator go off.|
|8.||Test-drive the vehicle, and check that the ABS indicator and brake system indicator do not come on.|