Side Impact Sensor (Second) Replacement

Removal


1.Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.

2.Disconnect the appropriate side curtain airbag 2P connector.

3.Disconnect the side impact sensor (second) 2P connector (A) from the floor wire harness.

 

4.Remove the Torx bolt (B) using a Torx T30 bit, then remove the side impact sensor (second) (C).

Installation


1.Install the new side impact sensor (second) (A) with torx bolt (B), then connect the floor wire harness 2P connector (C) to the side impact sensor (second).

 

2.Reconnect the battery negative cable.

3.Install all removed parts.

4.After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.