DTC Troubleshooting: P0369 (8)

DTC P0369:  CMP Sensor B Intermittent Interruption

1.Note this freeze data:
  • Engine speed
  • Vehicle speed

2.Clear the DTC with the HDS.

3.Start the engine, and let it idle for 10 seconds.

4.Check the CMP NOISE B COUNT in the DATA LIST with the HDS.

Is 0 count indicated?


YES - Go to 7.


NO - Go to 5.


5.Test-drive the vehicle for several minutes in the range of the recorded freeze data.

6.Check the CMP NOISE B COUNT in the DATA LIST with the HDS.

Is 0 count indicated?


YES - Go to 7.


NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at CMP sensor B and the ECM/PCM.n


7.Check for poor or loose connections and terminals at these locations:
  • CMP sensor B
  • ECM/PCM
  • Engine ground
  • Body ground

Are the connections and terminals OK?


YES - Go to 8.


NO - Reconnect the connectors or terminals, then go to 11.

8.Check for damage on the CMP pulse plate B.

Is the plate damaged?


YES - Replace the CMP pulse plate B, then go to 11.


NO - Go to 9.


9.Turn the ignition switch OFF.

10.Replace CMP sensor B.

11.Turn the ignition switch ON (II).

12.Reset the ECM/PCM with the HDS.

13.Do the ECM/PCM idle learn procedure.

14.Start the engine, and let it idle for 10 seconds.

15.Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?


YES - If DTC P0369 is indicated, check for poor connections or loose terminals at CMP sensor B and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.


NO - Troubleshooting is complete.n