A/T Clutch Pressure Control Solenoid Valve A Test

1.Connect the HDS to the DLC (A).

 

2.Choose Clutch Pressure Control (Linear) Solenoid A in Miscellaneous Test Menu on the HDS.

3.Test the A/T clutch pressure control solenoid valve A with the HDS.

4.Follow instructions indicated on the HDS by the test result. If the HDS has not determined the cause of the failure, remove the A/T clutch pressure control solenoid A and test.

5.Remove the air cleaner housing.

6.Disconnect the A/T clutch pressure control solenoid valve A connector.

 

7.Measure A/T clutch pressure control solenoid valve A resistance at the solenoid valve A connector.

Standard:  3-10 W 

8.If the resistance is out of the standard, replace the A/T clutch pressure control solenoid valve A.

9.Connect the battery positive terminal to the A/T clutch pressure control solenoid valve connector terminal No. 1, and connect the battery negative terminal to the No. 2 terminal. A clicking sound should be heard.

10.If no sound is heard, remove the A/T clutch pressure control solenoid valve A, and check the valve movement.

11.Remove the mounting bolts and the A/T clutch pressure control solenoid valve A.

 

12.Remove the ATF pipe (B), ATF joint pipes (C), O-rings (D), and gasket (E).

13.Check the fluid passage of the A/T clutch pressure control solenoid valve for dust or dirt, and clean the passage.

14.Connect the battery negative terminal to A/T clutch pressure control solenoid valve connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1. Make sure the A/T clutch pressure control solenoid valve moves.

 

15.Disconnect one of the battery terminals, and check valve movement.

NOTE: You can see valve movement through the fluid passage in the mounting surface of the A/T clutch pressure control solenoid valve A body.

16.If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace the A/T clutch pressure control solenoid valve A.

17.Install the new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes.

18.Install the new O-rings over the ATF joint pipes.

19.Install the A/T clutch pressure control solenoid valve A.

20.Check the A/T clutch pressure control solenoid valve A connector for rust, dirt, or oil, then connect the connector securely.

21.Install the air cleaner housing.