A/T Clutch Pressure Control Solenoid Valve B and C Replacement

1.Disconnect the battery negative terminal, then disconnect the battery positive terminal.

2.Remove the battery hold-down bracket, then remove the battery and battery tray.

3.Remove the battery base.

4.Disconnect the A/T clutch pressure control solenoid valve B and C connectors.

5.Remove the mounting bolts, harness clamp bracket (A), and the A/T clutch pressure control solenoid valve B and C.

 

6.Remove the ATF joint pipes (D), O-rings (E), and gasket (F).

7.Check the fluid passage of the A/T clutch pressure control solenoid valve for dust or dirt, and clean the passage.

8.Install the new gasket on the transmission housing, and install the ATF joint pipes.

9.Install the new O-rings over the ATF joint pipes.

10.Install the A/T clutch pressure control solenoid valve B and C, and harness clamp bracket.

11.Check the A/T clutch pressure control solenoid valve B and C connector for rust, dirt, or oil, then connect the connectors securely.

12.Install the battery base, battery tray, and battery, then secure the battery with its hold-down bracket.

13.Connect the battery terminals.

14.Perform the power window control unit reset procedure.