Transfer Housing Tapered Roller Bearing Outer Race Replacement

Special Tools Required
Handle driver (  07749-0010000)
 

Oil seal driver attachment (  07947-SD90101)
 
Bearing installer attachment (  07KAF-PS30120)
 
Bearing installer attachment (  07LAF-PZ70110)
 
Installer shaft, 14 x 165 mm (  07JAF-SJ80110)
 
Installer nut, 14 mm (  07JAF-SJ80120)
 


NOTE: Replace the bearing with a new one whenever the outer race is replaced.

1.Remove the 50 mm bearing outer race (A), 62 mm bearing outer race (B), and 57 mm bearing outer race (C) from the transfer housing by hand. If the 57 mm outer race cannot be removed by hand, remove it by heating the transfer housing to about 100°C (212°F) with a heat gun. Do not heat the housing more than 100°C (212°F). Some 57 mm outer races are press-fitted in the transfer housing.

 

2.Install the 57 mm bearing outer race (A) in the transfer housing (B) with the special tools.

 

3.Install the 62 mm bearing outer race and 50 mm bearing outer race in the transfer housing with the special tools.