Engine Mount Replacement - Side

1.Make sure you have the anti-theft codes for the radio and navigation system, then write down the customer's audio presets.

2.Disconnect the negative cable from the battery first, then the positive cable.

3.Support the engine with a jack and wood block under the oil pan.

4.Remove the upper torque rod.


5.Remove the side engine mount bracket.


6.Remove the side engine mount.


7.Install the new side engine mount.

8.Install the side engine mount bracket (A), then loosely tighten the new bolt/nuts (B), and loosely tighten the bolt (C).


9.Remove the battery.

10.Remove the air cleaner housing.

11.Remove the harness clamps, then remove the battery base.

12.Loosen the transmission upper mount bracket bolt (A) and transmission upper mount bolt/nuts (B).


13.Remove a jack.

14.Tighten the side engine mount mounting bolts/nuts in the numbered sequence shown.


15.Tighten the transmission upper mount/bracket mounting bolts/nuts in the numbered sequence shown.


16.Install the upper torque rod (A), then tighten the new bolts in the numbered sequence shown.


17.Install the battery base, then install the harness clamps.

18.Install the air cleaner housing.

19.Install the battery. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.

20.Enter the anti-theft codes for the radio and the navigation system, then enter the customer's audio presets.

21.Do the power window control unit reset procedure.

22.Set the clock.