Fuel Gauge Sending Unit Replacement

Special Tools Required
Fuel sender wrench (  07AAA-S0XA100)
 



1.Remove the fuel fill cap.

2.Fold the rear seats forward, and pull back the carpet to expose the access panel.

3.Remove the access panel (A) from the floor.

 

4.Disconnect the fuel pump 5P connector (B).

5.Disconnect the quick-connect fitting (C) from the fuel tank unit.

6.Using the tool, loosen the fuel tank unit locknut (A).

 

7.Remove the locknut (A) and the fuel pump assembly.

 

8.Remove the fuel gauge sending unit (B).

9.Install the fuel gauge sending unit in the reverse order of removal with a new base gasket (C) and new locknut, then check these items:

  • When connecting the wire harness, make sure the connection is secure and the connector (D) is firmly locked into the place.
  • When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
  • When installing the fuel pump assembly align, the marks (E) on the fuel tank (F) and the fuel pump assembly (G).