Fuel Line/Quick-Connect Fitting Installation

1.Check the contact area (A) of the line (B) for dirt or damage, and clean it if needed.

 

2.Insert a new retainer (A) into the connector (B) if the retainer is damaged, or after:

  • replacing the fuel feed line.
  • replacing the fuel gauge sending unit.
  • removing the retainer from the line.

 

3.Before connecting a new fuel tube/quick-connect fitting assembly (A), remove the old retainer (B) from the mating line.

 

4.Align the quick-connect fittings with the line (A), and align the retainer locking tabs (B) with the connector tabs (C). Then press the quick-connect fittings onto the line until both retainer pawls lock with a clicking sound.

NOTE: If it is hard to connect, put a small amount of new engine oil on the line end.

Connection with new retainer: 

Reconnection to existing retainer: 

5.Make sure the connection is secure and that the tabs are firmly locked into place; check visually and by pulling the connector.

 

6.Reconnect the negative cable to the battery, and bleed the fuel system. Start the engine, and check that there is no leakage in the fuel supply system.