VSA Modulator-Control Unit Removal and Installation

NOTE:

Removal


1.Turn the ignition switch OFF.

2.Disconnect the negative cable from the battery.

3.Remove the expansion tank without disconnecting hoses.

 

4.Pull up the lock (A) of the VSA control unit 47P connector (B), and the connector disconnects itself.

 

5.Disconnect the six brake lines.

6.Remove the VSA modulator-control unit (C)/bracket (D) from the body.

7.Remove the three 6 mm bolts, then remove the VSA modulator-control unit from the bracket.

Installation


1.Install the VSA modulator-control unit on the bracket, then tighten the three 6 mm bolts.

2.Install the VSA modulator-control unit/bracket on the body.

3.Reconnect the six brake lines, then tighten the nuts.

4.Align the connecting surface of the VSA control unit 47P connector.

5.Carefully push in the lock of the VSA control unit 47P connector until you hear it click into place, then confirm the connector is fully seated.

6.Bleed the brake system, starting with the front wheels.

7.Install the expansion tank.

8.Start the engine, and check that the ABS and VSA indicators go off.

9.Test-drive the vehicle, and check that the ABS and VSA indicators do not come on.