M/T Reverse Shift Lever Clearance Inspection

1.Measure the clearance between the reverse shift lever (A) and reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to 2.

Standard: 0.05-0.50 mm (0.002-0.020 in.) 
Service Limit: 0.6 mm (0.024 in.) 

 

2.Measure the width of the reverse shift lever.

  • If the width is not within the standard, replace the reverse shift lever.
  • If the width is within the standard, replace the reverse shift fork.

Standard: 6.400-6.650 mm (0.2520-0.2618 in.) 

 

3.Measure the clearance between the reverse shift lever (A) and reverse shift piece (B) with a feeler gauge (C). If the clearance is more than the service limit, go to 4.

Standard: 0-0.4 mm (0-0.015 in.) 
Service Limit: 0.5 mm (0.020 in.) 

 

4.Measure the width of the reverse shift lever.

  • If the width is not within the standard, replace the reverse shift lever.
  • If the width is within the standard, replace the reverse shift piece.

Standard: 13.0-13.2 mm (0.51-0.52 in.)