M/T Differential Bearing Outer Race Replacement

Special Tools Required
Driver (  07749-0010000)
 

Attachment, 78 x 80 mm (  07NAD-PX40100)
 


NOTE:

1.Remove the oil seals from the transmission housing and clutch housing.

2.Remove the bearing outer race, spacer, and 81 mm shim from the transmission housing and clutch housing by heating about 100 °C (212 °F) with a heat gun. Do not reuse the thrust shim if the outer race was driven out.

 

 

3.Install the 81 mm shim (A), spacer (B), and bearing outer race (C) into the transmission housing (D) using the special tools.

 

4.Install the spacer (A), and bearing outer race (B) into the clutch housing (C) using the special tools.

 

5.Install the oil seals into the transmission housing and clutch housing.