DTC Troubleshooting: P0107 (3-1)

DTC P0107:  MAP Sensor Circuit Low Voltage

1.Turn the ignition switch ON (II).

2.Check the MAP SENSOR in the DATA LIST with the HDS.

Is about 0.2 V or less indicated?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM.n


3.Turn the ignition switch OFF.

4.Disconnect the MAP sensor/IAT sensor 2 4P connector.

5.Turn the ignition switch ON (II).

6.Check the MAP SENSOR in the DATA LIST with the HDS.

Is about 0.2 V or less indicated?


YES - Go to 12.


NO - Go to 7.


7.Measure voltage between MAP sensor/IAT sensor 2 4P connector terminals No. 2 and No. 4.

 

Is there about 5 V?


YES - Go to 15.


NO - Go to 8.

8.Turn the ignition switch OFF, and wait 30 seconds.

9.Disconnect ECM connector No. 1 (96P).

10.Connect MAP sensor/IAT sensor 2 4P connector terminal No. 2 to body ground with a jumper wire.

 

11.Check for continuity between ECM connector No. 1 terminal No. 33 and body ground.

 

Is there continuity?


YES - Go to 21.


NO - Repair open in the wire between the MAP sensor/IAT sensor 2 and ECM connector No. 1 terminal No. 33, then go to 17.

12.Turn the ignition switch OFF, and wait 30 seconds.

13.Disconnect ECM connector No. 1 (96P).

14.Check for continuity between MAP sensor/IAT sensor 2 4P connector terminal No. 1 and body ground.

 

Is there continuity?


YES - Repair short in the wire between the MAP sensor/IAT sensor 2 and ECM connector No. 1 terminal No. 89, then go to 17.


NO - Go to 20.


15.Turn the ignition switch OFF.

16.Replace the MAP sensor/IAT sensor 2.

17.Reconnect all connectors.

18.Turn the ignition switch ON (II).

19.Reset the ECM with the HDS.

20.Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?


YES - If DTC P0107 is indicated, check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.


NO - Troubleshooting is complete.n

21.Update the ECM if it does not have the latest software, or substitute a known-good ECM.

22.Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?


YES - If DTC P0107 is indicated, check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.


NO - If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM.n