CKP Pulse Plate Replacement

1.Remove the drive belt.

2.Remove the cylinder head cover.

3.Remove the crankshaft pulley.

4.Disconnect the crankshaft position (CKP) sensor connector and variable valve timing control (VTC) oil control solenoid valve connector.

5.Remove the VTC oil control solenoid valve.

6.Support the engine with a jack and wood block under the oil pan.

7.Remove the ground cable, and remove the upper bracket.

8.Remove the side engine mount bracket.

9.Remove the chain case.

10.Remove the CKP pulse plate.

 

11.Install the CKP pulse plate.

12.Check the chain case oil seal for damage. If the oil seal is damaged, replace the chain case oil seal.

13.Remove all of the old liquid gasket from the chain case mating surfaces, bolt and bolt holes.

14.Clean and dry the chain case mating surfaces.

15.Apply liquid gasket, P/N 08C70-K0234M, 08C70- K0334M, or 08C70-X0331S, evenly to the cylinder block mating surface of the chain case and to the inner threads of the holes.

16.Apply liquid gasket to the cylinder block upper surface contact areas on the chain case.

17.Apply liquid gasket, P/N 08C70-K0334M or 08C70- X0331S, evenly to the oil pan mating surface of the chain case and to the inner threads of the holes.

18.Install the new O-ring on the chain case. Set the edge of the chain case to the edge of the oil pan, then install the chain case on the cylinder block.

19.Install the side engine mount bracket.

20.Install the upper bracket and the ground cable.

21.Install the VTC oil control solenoid valve.

22.Connect the CKP sensor connector and VTC oil control solenoid valve connector.

23.Install the crankshaft pulley.

24.Install the cylinder head cover.

25.Install the drive belt.

26.K24A1, K20A4 (KE, KG, KS models) engines: Do the CKP pattern clear/CKP learn procedure.