Throttle Body Removal/Installation

Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, there will be serious injury to your fingers if the throttle valve is activated.

1.Remove the intake air duct (A).


2.Disconnect the throttle body connector (B), EVAP canister purge valve connector (C) and MAP sensor connector (D).

3.Disconnect the water bypass hoses (E), and plug the water bypass hoses.

4.Disconnect the vacuum hose (F).

5.Remove the harness clip (G) and the throttle body (H).

6.Install the parts in the reverse order of removal with a new gasket (I), then check these items: