Valve Seat Reconditioning
|1.||Inspect valve stem-to-guide clearance. If the valve guides are worn, replace them before cutting the valve seats.|
|2.||Renew the valve seats in the cylinder head using a valve seat cutter.|
|3.||Carefully cut a 45° seat, removing only enough material to ensure a smooth and concentric seat.|
|4.||Bevel the upper and lower edges at the angles shown in the illustration.|
Check the width of the seat and adjust accordingly.
|5.||Make one more very light pass with the 45° cutter to remove any possible burrs caused by the other cutters.|
|6.||After resurfacing the seat, inspect for even valve seating: Apply Prussian Blue compound (A) to the valve face. Insert the valve in its original location in the head, then lift it and snap it closed against the seat several times.|
|7.||The actual valve seating surface (B), as shown by the blue compound, should be centered on the seat.|
NOTE: The final cut should always be made with the 45° cutter.
|8.||Insert the intake and exhaust valves in the head, and measure valve stem installed height (A).|
|9.||If valve stem installed height is over the service limit, replace the valve and recheck. If it is still over the service limit, replace the cylinder head; the valve seat in the head is too deep.|