Steering Rack Guide Replacement
Manufactored in except HATC
NOTE: During removal/installation, do not allow dust, dirt, or other foreign materials to enter the gearbox.
|1.||Loosen the locknut (A), then remove the rack guide screw (B), conical springs (C), holder (D), needle roller (E), and roller (F) from the steering gearbox.|
|2.||Grease the inside of holder and the sliding surface and circumference of the roller.|
|3.||Install the roller, the needle roller, and the holder onto the gearbox housing. Wipe the grease off the threaded section (G) of the housing.|
|4.||Install the conical springs onto the holder.|
NOTE: Make sure the number of the conical springs and the direction when installing.
|5.||Apply sealant to the threads on the rack guide screw, then install and tighten it to 25 N·m (2.5 kgf·m, 18 lbf·ft). Loosely install the locknut.|
|6.||Adjust rack guide screw. After adjusting, check that the rack moves smoothly by sliding it right and left.|