SRS Cable Reel Replacement
|1.||Make sure the front wheels are aligned straight ahead.|
|2.||Disconnect the battery negative cable, and wait at least 3 minutes.|
|3.||Remove the driver's airbag.|
|4.||Remove the steering wheel bolt (A).|
|5.||Remove the steering wheel with a steering wheel puller.|
Do not tap on the steering wheel or steering column shaft when removing the steering wheel.
|6.||Remove the column cover screws (A), then remove the column covers (B, C).|
|7.||Disconnect the dashboard wire harness 4P connector (A) from the cable reel 4P connector (B), then disconnect the dashboard wire harness B 5P connector or 13P connector (C) from the cable reel (D).|
|8.||Release the tab (A), then remove the cable reel from the column.|
|1.||Before installing the steering wheel, align the front wheels straight ahead.|
|2.||If not already done, disconnect the battery negative cable, and wait at least 3 minutes.|
|3.||Set the cancel sleeve (A) so that the projections (B) are aligned vertically.|
|4.||Carefully install the cable reel (A) on the steering column shaft. Then connect the 5P connector or |
13P connector (B) to the cable reel, and connect the 4P connector (C) to the dashboard wire harness 4P connector (D).
|5.||Install the steering column covers.|
|6.||If necessary, center the cable reel (New replacement cable reels come centered.). Do this by first rotating the cable reel clockwise until it stops.|
Then rotate it counterclockwise (about 2 1/2 turns) until the arrow mark (A) on the cable reel label points straight up.
|7.||Align the projections on the cable reel with the holes on the steering wheel, and install the steering wheel with a new steering wheel bolt (A).|
|8.||Install the driver's airbag.|
|9.||Reconnect the battery negative cable.|
|10.||After installing the cable reel, confirm proper system operation:|