Inner Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before performing repairs or service.

NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Take care not to scratch the dashboard and related parts.
  • LHD is shown, RHD is symmetrical.

1.Open the glove box lid.

2.Gently pull out the inner glove box (A) to detach the clips, then remove it.

 

3.Install the glove box in the reverse order of removal. Insert a rib (B) on back of the box to the holder (C) of the steering hanger beam.