Under-dash Fuse/Relay Box Removal and InstallationSRS components are located in this area. Review the SRS component locations, and precautions and procedures in the SRS section before performing repairs or service.
|1.||Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.|
|2.||Remove the fuse lid cover.|
|3.||Disconnect the connectors from the fuse side of the under-dash fuse/relay box.|
|4.||Remove the mounting nuts (A) and down the under-dash fuse/relay box (B).|
|5.||Disconnect the connectors from the back of the under-dash fuse/relay box, and remove the fuse/relay box.|
NOTE: The SRS connector is a spring-loaded lock type.
|1.||Install the under-dash fuse/relay box in the reverse order of removal and connect all connectors to the under-dash fuse/relay box.|
|2.||Install the fuse lid cover.|
|3.||Connect both the negative cable and positive cable to the battery.|
|4.||Enter the anti-theft code for the radio, then enter the customer's radio station presets.|
|5.||Confirm that all systems work properly.|