Blower-Heater Unit/Core ReplacementSRS components are located in this area. Review the SRS component locations, and precautions and procedures in the SRS section before performing repairs or service.
NOTE: LHD type is shown, RHD type is symmetrical.
|1.||Disconnect the negative cable from the battery.|
|2.||With air conditioning; disconnect the suction and receiver lines from the evaporator core.|
|3.||When the engine is cool, drain the engine coolant from the radiator.|
|4.||Slide the hose clamps (A) back, then disconnect the inlet heater hose (B) and the outlet heater hose (C) from the heater core. Engine coolant will run out when the hoses are disconnected; drain it into a clean drip pan. Be sure not to let coolant spill on the electrical parts or the painted surfaces. If any coolant spills, rinse it off immediately.|
|5.||Remove the dashboard.|
|6.||Disconnect the drain hose (A) with air conditioning. Remove the clips (B), the mounting bolts, the mounting nuts, and the blower-heater unit (C).|
|7.||Remove the blower unit from the heater unit.|
|8.||Remove the self-tapping screws and the pipe cover (A). Remove the self-tapping screw and the pipe clamp (B), then carefully pull out the heater core (C) so you don't bend the inlet and outlet pipes.|
|9.||With air conditioning; remove the self-tapping screws and the pipe cover (D). Remove the bolts, the inlet and outlet pipes (E), and the expansion valve (F). If necessary, remove the self-tapping screws and the blower resistor (G). Remove the evaporator temperature sensor connector (H), then remove the self-tapping screws and the duct (I). Pull out the evaporator core (J) with the plate (K).|
|10.||Install the heater core and the evaporator core (with air conditioning) in the reverse order of removal.|
|11.||Install the heater unit in the reverse order of removal, and note these items:|