Rear Window Defogger Wire RepairNOTE: To make an effective repair, the broken section must be no longer than one inch.
|1.||Lightly rub the area around the broken section (A) with fine steel wool, then clean it with alcohol.|
|2.||Carefully mask above and below the broken portion of the defogger wire (B) with transparent tape (C).|
|3.||Using a small brush, apply a heavy coat of silver conductive paint extending about 1/8²on both sides of the break. Allow 30 minutes to dry. Thoroughly mix the paint before use.|
|4.||Check for continuity in the repaired wire.|
|5.||Apply a second coat of paint in the same way. Let it dry 3 hours before removing the tape.|