The drive controller is only on loaders equipped with the SJC option. This controller processes information for the drive functions. The drive controller is located…

Lift and block the rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device.…

The Bobcat Controller (ACS) is part of the Advanced Control System (ACS) which is a selectable foot/hand control system. Electrical actuators shift the spools on…

Lift and block the rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device.…

The main controller provides information to all other controllers. All loaders have a main controller. The main controller is located behind the access panel near…

Remove the screws (Items 1) [Figure 60-60-6] from the light cover. NOTE: The wires for the switch will hold the light cover. Do not pull…

Remove the bulb assembly (Items 1 & 2) from the light housing (Item 3) [Figure 60-60-4] by turning bulb assembly a 1/4 turn. Using care…

Open the rear door. Disconnect the negative(-) cable from the battery. (See Removal And Installation on Page 60-20-1.) Remove the light housing (Item 1) [Figure…