Clean the surface of the cylinder head. Put a straight edge (Item 1) [Figure 60-80-21] on the cylinder head. NOTE: Do not put the straight…
Use a valve spring compressor to compress the valve springs [Figure 60-80-19]. Remove the valve cap (Item 1) and valve spring collet (Item 2) [Figure…
Remove the glow plug lead (Item 1), breather hose (Item 2), and valve cover bolts (Item 3) [Figure 60-80-8]. Remove the valve cover (Item 4)…
Remove the timing gearcase cover. (See Timing Gearcase Cover Removal And Installation on Page 60-100-1.) Make sure the timing marks are in correct alignment when…
Adjust the valve clearance with the engine stopped and cold. The correct valve clearance is 0,18 – 0,22 mm (0.007 – 0.0087 in) [Figure 60-80-5].…
Remove the air cleaner. (See Removal And Installation on Page 60-40-1.) Disconnect the negative (-) cable from the battery. Remove the nut and wire harness…
Disconnect the glow plug wire harness and connecting strap. Use an ohmmeter to check the glow plugs [Figure 60-80-1]. Touch one probe to the end…
The tool listed will be needed to do the following procedure: OEM1064 – Injector Nozzle Tester Connect the injection nozzle to a nozzle tester [Figure…
The tool listed will be needed to do the following procedure: OEM1064 – Injector Nozzle Tester Set the injection nozzle to a nozzle tester, and…
The tools listed will be needed to do the following procedure: MEL4200 – Injector Nozzle Tester MEL4201 – Injector Nozzle Tester Adapter Set Connect the…