Pry down on the linkage (Item 1) [Figure 60-20-16] and remove the linkage from the actuator. Remove the bolt (Item 1) [Figure 60-20-17]. Cut and…

The engine speed control components must be calibrated any time the controller (Item 1) [Figure 60-20-6] and or the actuator (Item 1) [Figure 60-20-7] has…

Remove the instrument panel / controller. (See Removal And Installation on Page 50-100-1.) Disconnect the wire harness from the control (Item 1) [Figure 60-20-3]. Remove…

Remove the console cover. (See Console Cover Removal And Installation on Page 40-50-1.) Pull up on and remove the engine speed control knob (Item 1)…

The tools listed will be needed to do the following procedure: MEL10630 – Engine Compression Kit MEL1631 – Compression Adapter The engine must be at…

Disconnect the negative ( – ) cable on the battery. (See Removal And Installation on Page 50-20-2.) Drain the hydraulic reservoir. (See Removing And Replacing…

The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…

If the standard size bearing cannot be used due to excessive wear of the crankpin and crank journal use undersize or oversize bearings. For undersize…