The data display screen (Item 5) [Figure 50-90-2] can be set to display engine rpm. With the engine running, press and release the information button…
The JOB CLOCK can be set to record accumulated hours for a particular job. Press and release the information button (Item 4) until JOB light…
This allows the operator to Unlock the password feature so that a password does not need to be used every time you start the engine.…
Perform Password Entry at left, but do not start the engine. Press and hold the ENTER CODE button (Item 1) for three seconds. CodE 1…
Press ENTER CODE button (Item 1). The panel will become lighted and there will be two short beeps. CodE will appear on the data display…
All new machines with keyless option arrive at the Bobcat Dealerships with the panel in locked mode. This means that a password must be used…
Use an ohmmeter to check the resistance of the fuel sender. Insert one of the ohm tester leads into each of the fuel sender electrical…
Remove the negative battery cable. (See Removal And Installation on Page 50-20-2.) Remove the floor mat. (See Removal And Installation on Page 40-110-1.) Disconnect the…