Drain the cooling system. Remove the alternator belt. Remove the water pump bolts. Remove the water pump [Figure 70-50-17]. Installation: Always use a new gasket…

Remove bolts (Item 1) [Figure 70-50-16] and discard. Reverse removal procedure for installation. Installation: Torque fan motor mounting bolts and nuts (Item 1) to 25…

Remove the lock nut and spacer (Item 1) [Figure 70-50-14]. Installation: Tighten the nut to 45 – 55 ft.-lb. (61 – 75 N•m) torque. Use…

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab.(See Raising on Page 10-30-2.)…

NOTE: The seals, O-rings and coil nut on the proportioning valve (Item 1) are available by ordering from Bobcat Service Parts. The fan motor (Item…

The proportioning valve meters the flow through the fan motor. The proportioning valve receives signals from the controller which gathers information from both the engine…

Stop the engine and open the rear door. Remove the rear grill. (See Removal And Installation on Page 50-60-1.) Remove the oil cooler. (See Removal…

Disconnect the wire harness connector (Item 1) [Figure 70-40-1] from the air cleaner sensor on the air cleaner. Loosen the hose clamp (Item 1) [Figure…

Stop the engine and open the rear door. Remove the rear grill. (See Removal And Installation on Page 50-60-1.) Remove the exhaust pipe clamp (Item…

Remove the spring (Item 1) [Figure 70-21-10] from the foot speed control assembly. Remove the bushing/nut (Item 1) [Figure 70-21-11] from the pedal lever. Remove…