The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…

Remove the floor mat and floor panel. (See Removal And Installation on Page 40-110-1.) Remove the three screws (Item 1) [Figure 40-230-1]. Remove the screws…

Loosen the two nuts and two bolts (Item 1) [Figure 40-220-6] and adjust the latch. Loosen the two nuts (Item 1) [Figure 40-220-6] and adjust…

Remove the nut, bolt and clamp (Item 1). Remove the bolts and nuts (Item 2) and remove the latch (Item 3) [Figure 40-220-3]. Remove the…

Open the right side cover. Remove the clip (Item 1). Support the cover and separate the support (Item 2) [Figure 40-220-1]. Support the cover and…

Install bushing (Item 1), O-ring (Item 2) and bushing (Item 3) [Figure 40-211-24] in both locking pin bores. Install reversing lever (Item 1), pin (Item…

Remove the eight bolts (Item 1) and cover (Item 2) [Figure 40-211-10]. Remove all sealant (Item 1) [Figure 40-211-11] from the housing and cover. NOTE:…

Remove the two bolts (Item 1) [Figure 40-211-8] and lock washers. Turn the threaded spindle (Item 1) counterclockwise until the locking mechanism (Item 2) [Figure…