Lower the bucket and blade to the ground. With the engine off, turn the key to the ON position, lower the console and move the…

Lower the boom / bucket and blade to the ground. With the engine off, turn the key to the ON position, lower the console and…

Clean all parts in solvent and dry with compressed air. Inspect all parts for wear or damage. Replace any worn or damaged parts. Always install…

NOTE: The drawings may appear different. The procedure is the same. Clean the outside of the clamp cylinder before disassembly. The following tools will be…

Remove the snap rings (Item 1) [Figure 20-26-5] and washers. Remove the pin (Item 1) [Figure 20-26-6]. Start the engine and retract the cylinder. Stop…

Remove the snap ring (Item 1) [Figure 20-26-1] and washer from the clamp cylinder pin. Remove the pin (Item 1) [Figure 20-26-2] from the rod…

Clean all parts in solvent and dry with compressed air. Inspect all parts for wear or damage. Replace any worn or damaged parts. Always install…

Clean the outside of the cylinder before disassembly. Use the following tools to disassemble the cylinder: MEL1074 – O-ring Seal Hook MEL1075 – Adjustable Gland…