NOTE: Always use new O-rings, gaskets, and seals when assembling the hydraulic pump. Put the hydraulic pump in the vise. Put a mark across the…
Author: MD
Ensure the hydraulic reservoir is filled to the correct level before starting the engine. (See Checking And Adding Fluid on Page 10-120-1.)
Raise the lift arms and install the lift arm support device. (See Installing on Page 10-20-1.) Stop the engine and raise the seat bar. Lift…
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10003 – Hydraulic Tester MEL10006 – Hydraulic…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the left side of the loader. The hydraulic…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the left side of the loader. The hydraulic…
Install the valve body in a vise and remove the valve (Item 1) [Figure 20-50-4] The valve body can be removed from the mounting bracket…
Install jackstands under the rear corners of the loader. Raise the operator cab. (See Raising on Page 10-30-1.) Remove the Remove the knob and washer…
Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm Bypass Control Knob (Item 1) [Figure 20-50-1]…