After installing the pedal, adjust the pedal so that there is clearance under the rear of the pedal. The valve spool must travel full stroke…
Author: Jack
Remove the bolt (Item 1) [Figure 50-90-1] and nut from the pedal linkage. Installation: Tighten the bolt and nut to 25-28 ft.-lbs. (34-38 Nm) torque.…
Loosen the fuel level sender (Item 1) [Figure 50-80-7] with a wrench. Turn the fuel level sender (Item 1) [Figure 50-80-7] out and remove it…
Remove the cover (Item 1) [Figure 50-80-1] which is installed over the fuel drain near the rear of the chaincase. Installation: Tighten the cover mounting…
Disconnect the spring (Item 1) [Figure 50-70-10] from the rear door. Remove the bolt and nut (Item 2) [Figure 50-70-10] from the latch. Remove the…
Remove the door latch mounting bolts (Item 1) [Figure 50-70-9] from the door latch mechanism. Installation: Tighten the mounting bolts to 80-90 in.-lbs. (9-10 Nm)…
Loosen the striker assembly mount bolts (Item 1) [Figure 50-70-7]. Align the striker assembly in the center of the mounting holes. NOTE: Tighten the striker…
Remove the lock nut (Item 1) [Figure 50-70-6]. Remove the rollers (Item 2) and the spacer (Item 3) from the bolt (Item 4) [Figure 50-70-6].…
Remove the two striker mount bolts (Item 1) [Figure 50-70-4] and [Figure 50-70-5]. Remove the striker assembly from the loader.
Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness. Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See…