Open the rear door and raise the rear grill [Figure 50-60-4]. Remove the gas cylinder rod end (Item 1) [Figure 50-60-5] from the rear grill.…
Author: Jack
Open the rear door and raise the rear grill [Figure 50-60-1]. Remove the base end of the cylinder off the stationary ball joint mounted on…
Roll the Bob-Tach fully forward. Stop the engine. Remove the Bob-Tach frame from the lift arms. (See Removal And Installation on Page 50-40-1.) Install jack…
Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-41-6], spring and wedge. Use a punch and hammer, remove the…
Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (approximately 3 inches) under each side of the Bob-Tach [Figure 50-41-1]. Lower…
Remove and replace the Bob-Tach stop (Item 1) [Figure 50-40-14] (both sides) if worn or damaged. NOTE: The Bob-Tach stop (Item 1) [Figure 50-40-14] must…
Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-40-8], spring and wedge. Remove the lever mounting bolt and nut…
Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (Item 1) approximately 3 inches thick under each side of the Bob-Tach.…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the operator seat. (See Removal And Installation on Page 50-31-1.) Remove the…
Pull the seat back adjustment lever (Item 1) [Figure 50-31-10] and tilt the seat back all the way forward. Remove the two mounting screws (Item…