The drive controller is only on loaders equipped with the SJC option. This controller processes information for the drive functions. The drive controller is located…
Author: Jack
Lift and block the rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device.…
The Bobcat Controller (ACS) is part of the Advanced Control System (ACS) which is a selectable foot/hand control system. Electrical actuators shift the spools on…
Lift and block the rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device.…
The main controller provides information to all other controllers. All loaders have a main controller. The main controller is located behind the access panel near…
Remove the screws (Items 1) [Figure 60-60-6] from the light cover. NOTE: The wires for the switch will hold the light cover. Do not pull…
Remove the bulb assembly (Items 1 & 2) from the light housing (Item 3) [Figure 60-60-4] by turning bulb assembly a 1/4 turn. Using care…
Open the rear door. Disconnect the negative(-) cable from the battery. (See Removal And Installation on Page 60-20-1.) Remove the light housing (Item 1) [Figure…