Clean the area before installing the rubber molding. Install the rubber molding (Item 1) [Figure 50-123-4] around the edge of the front door frame starting…

Remove the wiper arm assembly (Item 1) [Figure 50-123-1]. Remove the two screws (Item 2) and the nut (Item 3) [Figure 50-123-1]. Secure the wiper…

Release the latch (Item 1) [Figure 50-122-1] and slide the front window back towards the rear of the operator cab. From inside the operator cab,…

Position the window in the recess area. Install the bolts (Item 1) [Figure 50-121-1] through the window grommets, the nylon bushings and through the cab…

Clean the area before installing the rubber molding. Install the rubber molding (Item 1) [Figure 50-120-2] around the edge of the rear opening in the…

Pull on the tag (Item 1) [Figure 50-120-1] on the rear window to remove the rubber cord. Using gloves, push the rear window out the…

Disconnect both of the electrical harness connectors from the loader harness (Item 1) [Figure 50-112-8]. Remove the bolts (Item 1) [Figure 50-112-8] to remove the…

Lift the rubber boot (Item 1) [Figure 50-112-5]. Remove the four screws (Item 1) [Figure 50-112-6] to lift the joystick control from the base. Disconnect…

The tools listed will be needed to do the following procedure: MEL1608-Joystick Test Harness [Figure 50-112-1] MEL1563 or 6689779-Remote Start Tool Multimeter Raise the lift…

To replace the rubber boot (Item 1) [Figure 50-111-22] on the control panel, remove the control lever. (See Boot Removal And Installation on Page 50-110-1.)…